Introduction
If you own a Maytag dryer, it’s important to know how to replace the belt. Over time, the belt can wear down and break, causing your dryer to stop working properly. In this article, we’ll walk you through the steps to replace the Maytag dryer belt.
Step 1: Turn Off the Power
Before you begin, make sure to turn off the power to your dryer. This is important to avoid any accidents while working on the machine. You can do this by unplugging the dryer or turning off the circuit breaker.
Step 2: Access the Belt
Next, you’ll need to access the belt. This will require removing the front panel of the dryer. You can do this by using a putty knife to release the clips holding the panel in place. Once the panel is off, you’ll be able to see the belt.
Step 3: Remove the Belt
To remove the belt, you’ll need to release the tension. This can be done by pulling the idler pulley towards the center of the dryer. With the tension released, you can slip the belt off the motor and idler pulleys.
Step 4: Install the New Belt
Now it’s time to install the new belt. Begin by placing the belt around the drum, making sure it’s in place. Then, loop the belt around the motor and idler pulleys. With the belt in place, release the tension by pulling the idler pulley towards the center of the dryer.
Step 5: Test the Belt
Once the belt is in place, it’s important to test it before putting the dryer back together. You can do this by manually turning the drum to make sure the belt is properly aligned and functioning.
Step 6: Reattach the Front Panel
With the new belt installed and tested, it’s time to reattach the front panel. Simply line up the clips and push the panel back into place.
Step 7: Turn the Power Back On
Finally, it’s time to turn the power back on. You can do this by plugging the dryer back in or turning the circuit breaker back on.
Conclusion
Replacing the Maytag dryer belt may seem like a daunting task, but it’s actually quite simple. By following these steps, you can have your dryer up and running again in no time. Just remember to always turn off the power before working on any electrical appliance, and be sure to test the new belt before putting the dryer back together.